Cambridgeshire · England
Bath re-enamelling & resurfacing in Toft, Cambridgeshire
Full bath re-enamelling and resurfacing for homes and businesses in Toft and across Cambridgeshire. Send photos for a free, fixed quote.
- Resurfacing from £350
- Lots of chips and rust spots
- Worn patches where water runs and sits
Different materials, different repairs
Pressed steel
Pressed steel baths take a new finish well, as long as any rust is dealt with first. Rust around the waste is common on steel, so we check it carefully.
Cast iron
A cast iron bath is heavy enough that most people never want to move it. Only the enamel surface wears or chips, and that’s the part we put right.
How we handle bath re-enamelling in Toft
We clean, repair and prime the bath before spraying the new finish. The preparation is what makes it last, so we don’t cut corners on it. We regularly repair cast iron baths, Victorian roll-tops and pressed steel baths, and common reasons people get in touch are staining under the taps and around the waste and several chips and rust patches.
Big or small, you get the same one-year guarantee.
- Where
- Toft (CB23)
- Region
- Cambridgeshire
- Guarantee
- 12 months on all our work
- Quote
- From £350. Fixed and free, based on pictures
- Phone
- 0345 017 0787
- Page updated
- 23 October 2026
Should you replace it?
A refit takes several trades and several days. Re-enamelling takes one technician and normally one day, with the bath ready the next day. Resurfacing from £350, with every job priced individually. Compared with replacing, a repair is generally a fraction of the price, because there’s no removal, plumbing or making good. Your fixed quote shows exactly what’s included.
Why book with us
- Colours mixed by hand to suit your surface
- Normally one visit, start to finish
- Every repair guaranteed for a year
- Same prices wherever you are
Read our full price list or bath cost comparison.
Should I try a DIY kit first?
If you do try a kit, read the instructions carefully, and do not use it until it has fully cured. If it fails, we can still put it right.
You can buy a DIY kit for most repairs, and they can make a small mark look better. The trouble is colour and preparation: they come in a handful of shades, and if the surface is not prepared the repair won’t last.
When to call us in Toft
By the time a bath is a few decades old, it may have a mix of issues: dull areas, chips, rust and staining. Re-enamelling deals with all of them in one go.
These are the problems we are asked about most:
- A roll-top that is seen better days
- An outdated colour you’d like to change
- A bath that stays dull however much you clean it
- Wear marks under the taps
What your quote should include
- How to care for the finish
- When it can be used again
- Whether the price is fixed and includes VAT
- Whether there are any call-out or travel charges
Toft: your questions answered
Can you change the colour of my bath?
Yes, most people go for white. Mention the colour you want when you send pictures.
Can tenants book a repair?
Of course. Check with your landlord; we can send the quote to them too.
What happens once I’ve sent pictures?
We look at the photos and reply with a fixed quote and some dates. If we need another angle, we will ask.
Can you quote from pictures?
Nearly always. We only ask to see it in person if the photos cannot show what we need.
Do you cover Toft?
Yes. We cover the whole UK and come to Toft. Send pictures and we’ll quote, or call 0345 017 0787.
Will the new finish last?
It depends on preparation, use and care. Properly prepared and looked after, it lasts well, and our work is guaranteed for a year.
How long does re-enamelling take?
One day for most baths, ready the following day. We’ll confirm timings when we quote.
Will it make a mess?
No. The work area is masked and covered, and we leave the room clean.
For landlords and businesses
Letting agents frequently send us photos straight from the inventory. You can have a price before you arrange access, and we liaise with tenants about access if you’d like us to.
Hospitality businesses can’t afford rooms out of action for long, so most of our work is done in a single visit. We can work around your bookings.
What happens on the day
The work is clean and fairly quiet, so you can carry on at home. We protect the area first, then the job itself takes the best part of a day. At the end we talk you through the curing time and the aftercare.
- The room is masked, protected and ventilated.
- We clean and degrease the bath and repair any chips or rust.
- The surface is prepared and a bonding primer applied.
- We spray several coats of new enamel finish.
- Once cured, normally by the following day, the bath is ready.
Getting ready for the visit
- Mention if the room is upstairs or in a flat
- Mention any parking restrictions or tricky access
- Let the surface dry out before the visit
Get a quote
No survey visit is needed: we price from photos. Use the quote form, or ring 0345 017 0787 to talk it through, and you’ll get a fixed figure back.
Related advice
What bath re-enamelling costs
Prices start from £350. Each job gets its own fixed price. This is what makes a difference:
- How much damage there is
- Whether it’s a chip, crack, burn or wear
- Previous DIY repairs that have to come out
- How easy the damage is to reach
The price reflects the work involved, not your postcode. You’ll see the full price before booking.
How to get a fixed price
Photographing the damage takes a minute. Try to send:
- Where you are, by postcode
- What it’s made of, if you know
- A wider photo showing the entire bath
- One sharp close-up of the damage
To get a price, send a couple of pictures using our quote form or ring us. We will say straight away whether it can be repaired.
Aftercare tips
It’s all simple stuff, just a few sensible habits:
- Keep toiletries on a shelf rather than in the bath
- Rinse off hair dye, oils and bath bombs right away
- Respect the curing time we give you
- Stick to gentle, non-abrasive cleaners
Wait for the curing time we give you before the first bath. Then, gentle cleaning with a soft cloth is enough.
Leave a peeling coating alone. Water gets under it and the damage spreads, so have it stripped and resurfaced.
Also in Toft
Where we work around Toft
Toft is about 6 miles west of Cambridge, in Cambridgeshire. Our work suits any type of property, from flats and terraces to detached houses and new builds, as well as offices, shops and holiday lets. We work in all 371 towns and villages across Cambridgeshire, from the larger towns to small villages. You can also see our page for London, about 48 miles away.
Postcode districts we cover here: CB23. Jobs here include addresses on High Street, Mill Lane and Miller's Road. Other places close to Toft include Caldecote (1 mile north-west), Kingston (1 mile south-west), Comberton (2 miles east), Great Eversden (2 miles south) and Little Eversden (2 miles south-east). Further out, we also cover Cambridge (6 miles east), St Neots (11 miles west), Huntingdon (13 miles north-west), St Ives (11 miles north), Royston (9 miles south) and Cambourne (3 miles north-west).
Near you in Toft
We visit homes around Kingston and Bourn Old Railway, Parish Church of St Andrew and Comberton Village College, among other places. A little further out are Nuffield Health Cambridge Hospital (5.8 miles east) and Orwell Toot Hill (3.4 miles south). For a walk, there is Hardwick Wood.
About our accreditations · Every repair comes with a one-year guarantee.
