Kent · England
Bath re-enamelling & resurfacing in Tower Hamlets, Kent
Problem with your bath in Tower Hamlets? We repair it in place, match it on site and guarantee the work for a year.
- Resurfacing from £350
- A coating lifting around the plughole
- A bath that stays dull however much you clean it
About our bath re-enamelling in Tower Hamlets
Re-enamelling works especially well on cast iron and steel, and we can resurface acrylic baths as well. You end up with a smooth, glossy surface. Typical jobs include an old resurfacing that’s failing and worn patches where water runs and sits, across acrylic baths, pressed steel baths and Victorian roll-tops.
You’re covered after we leave: our one-year guarantee applies to every job, and we will explain exactly what it covers when we quote.
- Area
- Tower Hamlets (CT17, CT16, CT15)
- Area hub
- Kent
- Cover
- One year on every repair
- Quotes
- From £350. Free and fixed, from your pictures
- Phone
- 0345 017 0787
- Last updated
- 23 October 2026
How we price bath re-enamelling
Prices start from £350. There’s no charge for travel to Tower Hamlets. The price comes down to:
- Whether old repairs or coatings need taking off
- The material and finish
- The colour and finish to match
- How much damage there is
It helps to know what pushes a price up or down: the amount of damage, the material, access to the area, and how many jobs we do in one trip. Send photos and you will get a fixed figure.
Quotes from your pictures
A couple of clear pictures is all it takes. Try to include:
- The material, if you know it
- Details of any past repairs
- Good light, ideally daylight, without flash glare
- One picture of the entire bath
Upload pictures of the damage and one of the entire item, with your CT17 postcode, and we’ll reply with a fixed quote.
Do you need bath re-enamelling in Tower Hamlets?
Enamel wears gradually. Years of cleaning, hard water and hot baths wear the gloss away, starting where water runs and sits.
These are the problems we are asked about most:
- A bath that stays dull however much you clean it
- An original cast iron bath that needs restoring
- Stains that will not shift
- A coating lifting around the plughole
Comparing quotes
- If travel is included in the price
- Whether the price is fixed and includes VAT
- What prep work is covered
- How the room is protected while they work
Work for landlords and builders
We also carry out snagging repairs for builders and developers, putting right damage done during fitting so nothing needs replacing. We hold CHAS, Constructionline and SafeContractor accreditations.
We are used to working with agents and managing companies. Send the address, pictures and access details and we will arrange it.
Repair or replace: which is better?
A replacement frequently means several trades over several days. Re-enamelling is one technician, generally one day, with the bath back in use the day after. Resurfacing from £350, with every job priced individually. A repair usually costs much less than people expect, especially compared with replacing and refitting. Send pictures and we will give you the exact figure.
Why Tower Hamlets customers choose us
- Every repair guaranteed for a year
- Work done at your home or business
- No extra charge for your area
- Colour-matched on site
See our prices page or guide to resurfacing and replacement costs.
Tower Hamlets: your questions answered
Will the new finish last?
A well-prepared finish lasts a long time if it’s looked after. Gentle cleaning, no suction mats.
How do I get a price for bath re-enamelling in Tower Hamlets?
Prices start from £350. Every job gets a fixed quote from your pictures. Send a close-up of the damage and a wider photo and your postcode.
What happens after I send pictures?
We check the damage, the material and your postcode, then reply with a quote and the next dates we have.
Can you repair several things at once?
Yes. Combining jobs on one visit brings the cost down. Send photos of everything you’d like done.
Is repairing better than replacing?
Usually, if the item is otherwise sound. Repairing avoids the cost and disruption of replacing. If replacing would be better, we’ll say so.
Can pets and children be at home?
Keep pets and children away from the work area on the day, mainly so nothing gets touched before it has cured.
How long does re-enamelling take?
Normally a day, then it’s ready to use the following day. A badly pitted bath can need a second day.
Do you come to Tower Hamlets?
We do. We send a technician to Tower Hamlets for every job, and the price is the same as everywhere else.
Can I fix it myself?
A kit can be fine for a tiny mark out of sight. For anything you look at every day, anything that has rusted, cracked or holed, or anything on a coloured surface, a professional repair is worth it.
Kits are cheap and easy to find, but many of the jobs we do start with putting right a DIY repair. Doing it properly first is normally the cheaper route.
What we do, step by step
When we visit, we arrive at the time we’ve agreed, cover the area with dust sheets and masking, and set to work. The job usually takes a full day. We clean up when we’re done and tell you when it’s ready to use.
- The room is masked, protected and ventilated.
- Next we degrease the bath and fix chips and rust spots.
- The surface is prepared and a bonding primer applied.
- We spray on the new enamel finish in several coats.
- The bath is left to cure and can normally be used the day after.
Getting ready for the visit
- Let the surface dry out before the visit
- Point us to the nearest place to park
- Clear the area around the damage
How to get a price
You don’t need a survey visit. Nearly every job can be priced from pictures: we need a close-up, a wider picture and your postcode, and we will reply with a fixed quote.
Related advice
Repairs by material
Pressed steel
Steel baths re-enamel well, once any rust has been treated. Steel frequently rusts by the plughole, so we check it carefully.
Cast iron
Cast iron baths are the classic candidate for re-enamelling. They’re built to last, and only the surface wears, so a new finish makes them look new again.
Honest limits
We’ll always be straight with you, so here’s what a repair won’t do:
- Leaks from fittings rather than the bath
- A bath split right through the body
- Problems we cannot see until an old finish comes off
Not sure? Send photos and we’ll give you a straight answer before you book.
Surfaces we repair
- Pressed steel baths
- Acrylic baths
- Basins & shower trays
- Victorian roll-tops
- Cast iron baths
Places near Tower Hamlets
Other services in Tower Hamlets
Covering Tower Hamlets
Tower Hamlets is about 1 mile south of Dover, in Kent. We agree a date that works for you, and you will know when to expect us, so you are not left waiting in all day. We cover all 922 towns and villages in Kent. We work right across the region, from Tower Hamlets to London (65 miles away).
Here we cover the CT17, CT16 and CT15 postcode area. From Cow Lane, Odo Road and Eric Road or anywhere nearby, a technician can come to you. Tower Hamlets sits on or near the A256, so getting to you is simple. If you are just outside Tower Hamlets, we cover Charlton-in-Dover (1 mile north-east), Guston (2 miles north-east), Church Whitfield (2 miles north), East Langdon (3 miles north-east) and West Cliffe (3 miles north-east). We also work in nearby towns such as Canterbury (14 miles north-west), Folkestone (7 miles south-west), Ramsgate (15 miles north), Deal (7 miles north-east), Hythe (10 miles south-west) and Walmer (7 miles north-east).
Near you in Tower Hamlets
We visit homes around Dover Grammar School for Girls, High Meadow and The Eagle Inn. You’ll also find Church of St Peter and St Paul (under half a mile north-east), Priory Fields School (under half a mile south-west) and St Edmund's Catholic School (0.6 miles north-east). There’s a railway station in Tower Hamlets itself: Dover Priory station. A little further out are Dover Castle (1 mile east) and Royal Victoria Hospital (under half a mile east). Not far away are Dover Western Heights.
About our accreditations · Every repair comes with a one-year guarantee.
