Bolton · England
Bath chip & crack repair in Chequerbent, Bolton
Bath repair for Chequerbent, without a refit. Get a fixed price from your pictures, then book a visit.
- Repairs from £95
- Cracks in an acrylic bath
- Rust spots around the plughole
Bath repair in Chequerbent without replacing anything
We repair enamelled steel, cast iron and acrylic baths. Each material is repaired a little differently: rust is treated on metal baths, while cracks in acrylic are reinforced from underneath. Whether it’s a chip where the taps sit and a chipped rim or side, we can help, whatever the material.
You are covered after we leave: our one-year guarantee applies to every job, and we will explain exactly what it covers when we quote.
- Area
- Chequerbent (BL5)
- Region
- Bolton
- Warranty
- One year on every repair
- Quotes
- From £95. Free, fixed quote from pictures
- Phone
- 0345 017 0787
- Updated
- 23 October 2026
How the visit works
A typical visit goes like this: we arrive on time, sheet and mask the area around the job, carry out the work and clear up. Allow a few hours, depending on the damage. Before leaving, we tell you when it can be used and what to avoid for the first few days.
- First, we check the damage against your pictures and agree the plan.
- Loose enamel, rust and dirt are removed so the repair can bond.
- The damage is filled in layers and shaped to the curve of the bath.
- We tint the finish by hand to match the bath.
- The repair is polished to the same gloss as the bath and left to cure.
Getting ready for the visit
- Avoid using the area for a few hours before we arrive
- Make sure the room can be ventilated
- Tell us about any previous repairs or coatings
Getting a price
You don’t need a survey visit. Photos are enough for us to price nearly every job: send a close-up, a wider shot and your postcode, and we will come back to you with a fixed figure.
Related advice
When we’d advise against a repair
Not everything can be repaired, and we would rather say so up front. We cannot fix:
- A bath that moves underfoot, until its support is fixed
- Water coming from the waste or taps rather than the bath
- Cracks in parts of an acrylic bath we cannot get to from below
If in doubt, send photos and we’ll say what we think before you book.
Materials we work on in Chequerbent
- Cast iron enamel
- Roll-top & freestanding
- Acrylic
- Pressed steel enamel
- Whirlpool & spa baths
How to look after the repair
Most damage we see is avoidable. These habits help:
- Make sure an acrylic bath is firm underfoot
- Clean with warm water and a mild detergent
- Give the bath a quick rinse after use
- Get a dripping tap fixed promptly
A repaired bath needs no special treatment, beyond gentle cleaning. Avoid bleach-based and gritty cleaners and rinse after use.
Until we visit, a strip of waterproof tape over the damage helps, so water can’t get in. Take it off before we arrive.
Chequerbent and the surrounding area
Chequerbent is about 1 mile east of Westhoughton, in Bolton. Whether you are in the middle of Chequerbent or on the outskirts, the service is the same: fixed prices, tidy work and a one-year guarantee. We work in all 61 towns and villages in Bolton, from the larger towns to small villages. Our jobs stretch from Chequerbent to Manchester (12 miles away).
Jobs in BL5 work the same way as everywhere else we cover. If you are just outside Chequerbent, we cover Hunger Hill (1 mile north), Over Hulton (1 mile south-east), Rumworth (1 mile north), Middle Hulton (1 mile east) and Atherton (2 miles south). Larger places within reach include Bolton (3 miles north-east), Horwich (4 miles north-west), Halliwell (3 miles north-east), Farnworth (4 miles east), Great Lever (3 miles east) and Kearsley (5 miles east).
Landmarks near Chequerbent
Around Chequerbent, we work in homes near St Thomas CofE Primary School, Westhoughton High School and St Andrew's Church Over Hulton and the streets around them. Chequerbent’s nearest station is Hag Fold station, about 1.2 miles south of the centre. Other landmarks nearby include Blackrod Castle Croft (4.5 miles north-west) and Royal Bolton Hospital (2.7 miles east). The countryside around Chequerbent includes Nob End and Pennington Flash.
- Other local spots include Atherleigh (2.5 miles south)
What your bath is made of matters
Pressed steel
Pressed steel is thinner and lighter, with an enamel finish like cast iron. Exposed steel rusts fast, especially around the waste, so early repairs matter.
Composite and resin
Composite baths are dense and solid, and often freestanding. Chips and scratches can be filled and colour-matched, in much the same way.
Should I try a DIY kit first?
The difference between a kit and a professional repair is mostly in the preparation and colour. We clean and key the area properly, mix the colour to your surface and finish it to the same sheen, and the work is guaranteed.
DIY kits are sold for most surfaces, and they can make a small mark look better. Where they fall down is colour and preparation: they come in a handful of shades, and if the surface isn’t prepared the repair will not last.
How we price bath repair
Prices start from £95. Prices are worked out job by job. What matters most is:
- The size and number of damaged areas
- What the surface is made of
- Whether it’s a chip, crack, burn or wear
- How easy the damage is to reach
A repair is priced on what needs doing, not where you live. The full price is agreed before booking, with no extras added later.
Getting a price from pictures
You can take the pictures on your phone, there is no need for anything special. Just make sure we can see:
- Details of any past repairs
- The material, if you know it
- Daylight if possible, and no flash reflection
- One sharp close-up of the damage
Call 0345 017 0787 or use the quote form. With one close-up and one wider picture, we can give you a fixed price.
Nearby places to Chequerbent
What else we do in Chequerbent
Landlord and trade work in Chequerbent
We regularly price jobs from inventory or check-out pictures. You can have a price before you arrange access, and we liaise with tenants about access if you’d like us to.
Housing associations and facilities teams use us for planned and reactive repairs. Repairing in place avoids the disruption of a replacement, which matters when someone is living in the home.
Signs you need bath repair in Chequerbent
Baths take more knocks than people expect: bottles, shower heads and razors are dropped every day, and fittings press hard against the enamel. Sooner or later, most baths pick up a chip.
You may need us if you’ve spotted:
- A chip where the taps sit
- A hole punched through by something heavy
- An old repair that has yellowed or come loose
- A chipped rim or side
What your quote should include
- Whether a trained technician does the job
- How the colour is matched
- Aftercare advice
- What happens if the damage is worse than the pictures show
Your questions about bath repair in Chequerbent
How long before I can use the bath?
Normally by the following day, depending on the repair.
Will there be a smell?
Some materials have a smell while they’re applied, so we ventilate the room. It fades as everything cures.
Is a cracked acrylic bath repairable?
In most cases. The back of the crack is strengthened before the front is filled and refinished, so access behind the panel is important.
Do you work for landlords and businesses?
Yes, often. We can quote for several properties together and work between tenancies.
Do I need to be at home?
We need someone to let us in. You don’t need to watch us work.
What do you need from me?
Just photos, your postcode and a contact number. On the day, we only need access to the room.
Will I be able to see the repair?
We aim for a repair you can’t easily find. How well it disappears depends on the condition of the rest of the bath, and we’ll tell you what to expect.
Do you cover Chequerbent?
We do. Technicians travel to Chequerbent from across the region, with no extra charge for travel.
About our accreditations · Every repair comes with a one-year guarantee.
