Somerset · England
Bath Repair in Wearne
Damaged bath in Wearne? We put it right where it is, mix the colour on the day and back it with a one-year guarantee.
- Repairs from £95
- Damage beneath the taps
- Rust spots around the plughole
Repairs by material
Acrylic
Acrylic baths are moulded sheet reinforced underneath. There’s no rust, but cracks, holes and scratches happen, and cracks need support from behind to stay fixed.
Composite and resin
Composite baths are dense and solid. Chips and scratches can be filled and colour matched, in much the same way.
About our bath repair in Wearne
A typical bath repair is a few hours’ work, and you can generally bathe again the day after. You won’t need a plumber or tiler, because nothing is disconnected. Typical jobs include a cracked acrylic bath and rust by the waste and overflow, in roll-top & freestanding, whirlpool & spa baths and cast iron enamel.
We stand behind the work with a one-year guarantee, so you’re not left on your own once we’ve gone.
- Location
- Wearne (TA10)
- Area hub
- Somerset
- Cover
- One year on every repair
- Quote
- From £95. Fixed and free, based on photos
- Telephone
- 0345 017 0787
- Updated
- 23 October 2026
When a repair is not the answer
A few problems are outside what a surface repair can do:
- Cracks in parts of an acrylic bath we can’t get to from below
- Leaking fittings, which need a plumber
- A bath that moves underfoot, until its support is fixed
If in doubt, send pictures and we will say what we think.
Materials we work on in Wearne
- Whirlpool & spa baths
- Acrylic
- Cast iron enamel
- Roll-top & freestanding
- Pressed steel enamel
DIY kit or professional repair?
What a professional repair adds is preparation, colour matching and finishing. We clean and key the area properly, mix the colour to your surface and finish it to the same sheen, and the work is guaranteed.
If you are set on a kit, follow its instructions closely, make sure the area is clean and completely dry, and give it the full curing time. If it doesn’t work out, we can still repair it properly.
Looking after it afterwards
Good habits make a big difference to how long a repair lasts. Here’s what we suggest:
- Rinse it down after each bath
- Protect the bath with a towel when doing jobs nearby
- Clean with warm water and a mild detergent
- Get a dripping tap fixed promptly
Treat the repaired area like the rest of the bath: warm water, washing-up liquid and a soft cloth. Avoid scourers and gritty cream cleaners.
A small chip is a quick job. Left alone, they stain and can rust, so early repair saves time and money.
How it works
You don’t need to empty the room. Everything we use comes in the van with us, put protection down and get going once we’ve agreed what we’re doing. It typically takes two to three hours for most chips, and you’re welcome to carry on with your day while we work.
- We start by cleaning the damage and taking out loose enamel and rust.
- Next we fill the damage and sand it smooth and level.
- We tint the finish on the day to suit your bath’s shade of white or colour.
- We apply the finish coats and polish the repair so it blends in.
- Once it has cured, normally by the following day, the bath is ready to use.
Getting ready for the visit
- Keep a parking space free if you can
- Plan for the room to be out of bounds to pets and children
- Clear the area around the damage
Getting a price
Getting a quote takes a couple of minutes: photograph the damage, then the entire bath, include your postcode and send them to us. What comes back is a fixed price, not a guess.
Advice
Also in Wearne
Our work in Wearne
Wearne is about 6 miles south-west of Street, in Somerset. We agree a date that works for you, and you will know when to expect us, so you’re not left waiting in all day. Wearne is one of 640 places in Somerset where we work.
Every address in TA10 is covered. Other places close to Wearne include Combe (1 mile west), Pict's Hill (1 mile south-east), Langport (1 mile south), Wagg (1 mile south-east) and Low Ham (1 mile north). We also work in nearby towns such as Taunton (12 miles west), Bridgwater (10 miles north-west), Yeovil (10 miles south-east), Chard (14 miles south-west), Burnham-on-Sea (15 miles north-west) and Wells (13 miles north-east).
Near you in Wearne
Our clients here include homes close to The Black Swan Inn, Church without dedication and Huish Episcopi Primary School, among other places. The countryside around Wearne includes Burrow Mump and West Sedgemoor RSPB reserve.
FAQs for Wearne
Will you leave a mess?
Dust sheets and masking go down before we start, and we clean up when we’ve finished.
Can you redo an old repair?
Yes. We remove the old filler and start again. Mention it when you send photos.
Do you work in Wearne?
Yes. We cover the whole UK and travel to Wearne. Send pictures and we will quote, or call 0345 017 0787.
Can I get a quote without a visit?
In nearly every case. If photos don’t show enough, we will ask for another angle.
Does someone need to be in?
Yes. The technician needs access to the room for the visit, at a time that suits you.
Will the repair show?
On a bath in good condition, a colour matched repair is very hard to spot. On worn enamel, it can look shinier than the rest.
I rent my home. Can I book you?
Yes, though it’s best to check with your landlord first. Many landlords are happy for a repair to be arranged.
What does bath repair cost?
Prices start from £95. Every job gets a fixed price based on photos of the damage. Send a close-up and a picture of the whole item with your TA10 postcode.
Do you need bath repair in Wearne?
Many chips happen while the bathroom is being fitted. Tradespeople drop tools and tiles into the bath, frequently before anyone notices. We repair snagging damage like this regularly.
Common reasons people in Wearne contact us include:
- A cracked acrylic bath
- Deep scratches in acrylic
- A chipped rim or side
- A kit repair that didn’t last
Comparing quotes
- Whether the price covers travel
- How to care for the finish
- How soon you can use it again
- Who turns up on the day
For landlords and businesses
Rented homes see more wear and tear, and replacing items every time a tenant leaves is expensive. Repairing between tenants keeps the property presentable for less.
Letting agents often send us pictures straight from the inventory. You can have a price before you arrange access, and we can arrange access with the tenant directly if that helps.
What affects the price in Wearne
Prices start from £95. We do not charge extra for travel to Wearne. The price depends on:
- The type of damage
- What the surface is made of
- Access to the area
- Doing more than one item at once
No two jobs are quite the same, so each one is priced on its own. What’s damaged, how badly and how easy it is to reach all make a difference, and combining jobs on one visit brings the cost down.
Getting a price from photos
Most quotes are done from photos alone. To make it quick:
- What it’s made of, if you know
- Your postcode, so we can check dates
- Natural light rather than flash
- A close-up of the damage, in focus
For most jobs, pictures are all we need to give you a price. Tell us what happened and where you are, and we’ll send back a fixed quote and some dates.
About our accreditations · Every repair comes with a one-year guarantee.
