Staffordshire · England
Bath Re-enamelling for Harper's Gate homes
Full bath re-enamelling and resurfacing for homeowners, landlords and businesses in Harper's Gate. Send photos for a free, fixed quote.
- Resurfacing from £350
- A bath that stays dull however much you clean it
- Brown or grey marks that don’t clean off
Keeping it looking good
A little care keeps the finish looking good. Our advice:
- Rinse off hair dye, oils and bath bombs immediately
- A quick wipe after use keeps limescale away
- Have chips seen to early
- Use washing-up liquid and a soft cloth
Stick to mild, non-abrasive cleaners, avoid suction bath mats, and keep bottles and razors off the surface.
Don’t try to scrub a worn bath back to shine. It removes more of the surface and makes resurfacing more work.
Bath re-enamelling in Harper's Gate, done in place
The bath stays where it is, so the taps, tiles and plumbing aren’t touched. Most baths are done in one visit, and can be used again the next day. We are often asked to fix a peeling or bubbling previous coating and several chips and rust patches, in Victorian roll-tops, basins & shower trays and pressed steel baths.
A one-year guarantee comes with the work, just as it does everywhere we cover.
- Location
- Harper's Gate (ST13)
- Region
- Staffordshire
- Warranty
- One year on every repair
- Price
- From £350. Free and fixed, from your photos
- Call
- 0345 017 0787
- Last updated
- 23 October 2026
Should I try a DIY kit first?
We understand the appeal of fixing it yourself. The trouble is that kit repairs often look fine at first and then fail, and the old filler has to come out before a proper repair.
If you are set on a kit, follow its instructions closely and work on a clean, dry surface, and give it the full curing time. If it does not work out, we can still repair it properly.
Also near Harper's Gate
Also in Harper's Gate
Where we work around Harper's Gate
Harper's Gate is about 2 miles west of Leek, in Staffordshire. Our repair technicians come to homes and businesses in Harper's Gate, so you don’t need to take anything anywhere. Harper's Gate is one of 512 towns and villages in Staffordshire we cover. You can also see our page for Manchester, about 26 miles away.
Every address in ST13 is covered. We also travel to Rudyard (1 mile north), Horton (1 mile west), Poolend (1 mile east), Westwood (1 mile south-east) and Bridge End (1 mile east). We also work in nearby towns such as Newcastle-under-Lyme (9 miles south-west), Longton (9 miles south), Stone (15 miles south), Biddulph (4 miles west), Alsager (10 miles west) and Kidsgrove (7 miles west).
Around Harper's Gate
Our customers here include homes close to Church of St Michael, Horton St Michael's CofE First School and Westwood College. Further afield, we also cover the area around Brindley Mill And James Brindley Museum (1.7 miles east) and St Edward's Hospital (2.8 miles south-east). Open spaces near Harper's Gate include Coombes Valley RSPB reserve and Gun.
Signs you need bath re-enamelling in Harper's Gate
Enamel wears gradually. Abrasive cleaners, limescale and years of use dull the surface, starting where water runs and sits.
It’s worth getting a quote if you see:
- Staining under the taps and around the waste
- Wear marks under the taps
- An original cast iron bath that needs restoring
- An outdated colour you’d like to change
Before you book anyone
- What prep work is covered
- If travel is included in the price
- How to look after the finish
- Is the price fixed, and does it include VAT?
For landlords and businesses
We regularly work with letting and managing agents. Send the address, photos and access details and we’ll arrange it.
We also carry out snagging repairs for builders and developers, putting right damage done during fitting. We are CHAS, Constructionline and SafeContractor accredited.
When a repair isn’t the answer
Some problems need a builder, plumber or fitter rather than us:
- Problems we cannot see until an old finish comes off
- A bath that’s rusted through
- Leaks from fittings rather than the bath
Not sure? Send photos and we’ll give you a straight answer before you book.
Surfaces we repair
- Acrylic baths
- Cast iron baths
- Victorian roll-tops
- Pressed steel baths
- Basins & shower trays
What bath re-enamelling costs
Resurfacing from £350. We price every job individually, from your photos. What matters most is:
- What kind of damage it is
- How easy the damage is to reach
- Doing more than one item at once
- The colour and finish to match
Most people are surprised how affordable a repair is, especially compared with replacing and refitting. Send pictures and we’ll give you the exact figure.
How to get a fixed quote
Photographing the damage takes a minute, and it saves a visit. Try to send:
- Whether it’s been repaired or coated before
- A close-up of the damage, in focus
- Daylight if possible, and no flash reflection
- A coin beside the damage so we can judge size
No survey visit is needed: we price from pictures. Send them through the quote form, or call 0345 017 0787 if you’d rather talk it through, and we’ll come back with a fixed figure.
The process
Your technician turns up at the time we agreed with you and looks over the damage before anything else. Dust sheets and masking tape go down before we open a single tin. Most visits take most of the day, and we leave the room as we found it.
- We sheet, mask and ventilate the room.
- We remove the old silicone and deep clean the bath.
- We repair chips, rust spots and pitting.
- We key the bath and apply a bonding primer.
- Several coats of finish are sprayed on, then it cures.
How to prepare
- Tell us about parking, stairs or access
- Let us know which floor the room is on
- Clear toiletries, mats and anything else from around the area
Ask for a price
Ring 0345 017 0787, or send us pictures through the quote form. With one close-up and one wider picture, we can price the job.
Related advice
Repair or replace in Harper's Gate?
There are times replacing is better: if the bath is cracked through, if you want a different size or shape, or if you’re refitting the entire room anyway. Otherwise, resurfacing generally wins. Prices start from £350. No two jobs are quite the same, so we price each one individually. The size and type of damage, the material and access all make a difference, and doing several things on one visit costs less than separate visits.
What you get with us
- Colour-matched on site
- CHAS, Constructionline and SafeContractor accredited
- Same prices wherever you are
- Most jobs done in one visit
Read our prices page and resurfacing vs replacement cost guide.
Questions from Harper's Gate
Will the price change on the day?
We will show you and explain before doing anything extra. Nothing extra is done without your say-so.
Can you fix a peeling bath coating?
Normally, yes. We strip the failing coating and resurface it properly. Tell us about it when you ask for a quote.
Can you price it without visiting?
Typically, yes. Clear pictures let us give you a fixed quote without visiting.
Do I have to be there?
Yes. The technician needs access to the room for the visit, at a time we agree with you.
What areas do you cover?
Across the UK, and that includes Harper's Gate. Prices don’t change with location.
Can you repair something that’s been repaired before?
Yes, regularly. Removing the old work can add time, and that is in the quote.
Can you do more than one item on the same visit?
Yes, and it’s often cheaper. Just add the extra items to your pictures and we will quote them together.
Do you work in Harper's Gate?
Yes. We work across the UK and come to Harper's Gate and the rest of Staffordshire. Send pictures and we’ll quote, or call 0345 017 0787.
About our accreditations · Every repair comes with a one-year guarantee.
