Perth and Kinross · Scotland
Bath re-enamelling & resurfacing in Scoonieburn, Perth and Kinross
Our technicians come to Scoonieburn for full bath re-enamelling and resurfacing. Everything is done in place, with a one-year guarantee.
- Resurfacing from £350
- Staining under the taps and around the waste
- A peeling or bubbling previous coating
Bath re-enamelling in Scoonieburn without replacing anything
We re-enamel plenty of period and roll-top baths, which would be difficult and expensive to replace. Resurfacing them in place keeps the original bath. Common call-outs are for brown or grey marks that don’t clean off and an old resurfacing that’s failing, across acrylic baths, pressed steel baths and cast iron baths.
All of our repairs are guaranteed for twelve months in Scoonieburn and everywhere else. We return to put right any problem with the work.
- Where
- Scoonieburn (PH2)
- County
- Perth and Kinross
- Guarantee
- A year, on every repair
- Quote
- From £350. Free, fixed price from pictures
- Telephone
- 0345 017 0787
- Last updated
- 23 October 2026
Honest limits
A repair isn’t right for every job, for example:
- Plumbing leaks, which need a plumber
- Damage hidden under a previous coating, until it’s stripped back
- Steel that has corroded right through
Send us pictures and we’ll tell you honestly before you book.
Materials we repair
- Victorian roll-tops
- Pressed steel baths
- Cast iron baths
- Basins & shower trays
- Acrylic baths
How we price bath re-enamelling
Resurfacing from £350. There are no hourly rates or hidden extras. The price depends on:
- Whether it’s a chip, crack, burn or wear
- How much damage there is
- Unusual colours or finishes
- The material and finish
A repair normally costs much less than people expect, especially compared with replacing and refitting. Photos let us give you the exact figure.
Send pictures for a quote
Most quotes are done from photos alone. To help us price it:
- One picture of the entire bath
- Your postcode, so we can check dates
- Good light, ideally daylight, without flash glare
- Any details about the material
Getting a quote takes a couple of minutes: take one close-up and one wider shot of the bath, include your postcode and send them over. You will get a fixed price, not an estimate.
Our work in Scoonieburn
Scoonieburn is about 2 miles south-east of Perth, in Perth and Kinross. Whether you are in the middle of Scoonieburn or on the outskirts, the service is the same: fixed prices, tidy work and a one-year guarantee. Scoonieburn is one of 107 towns and villages in Perth and Kinross we cover. Our jobs stretch from Scoonieburn to Edinburgh (about 31 miles away).
We cover every part of the PH2 postcode area and the streets around it. Whether you live on Ethel Moorhead Place, Frances Gordon Road and Scoonieburn Hill or anywhere nearby, a technician can come to you. Neighbouring places we cover include Tarsappie (1 mile east), Oakbank (2 miles north-west), Perth (2 miles north-west), Bridge of Earn (2 miles south) and Forgandenny (3 miles south-west). Within a short drive, we also cover Blairgowrie and Rattray (15 miles north), Auchterarder (12 miles south-west), Kinross (11 miles south), Letham (3 miles north-west), Scone (3 miles north) and Tulloch (3 miles north-west).
What’s near Scoonieburn
Our clients here include homes close to Perth High School, among other places. For rail, the closest station is Perth station, roughly 1.4 miles north-west of the centre. Nearby you will also find St John's Shopping Centre (1.6 miles north) and Murray Royal Hospital (1.8 miles north). Green spaces nearby include Friarton Hill.
Places near Scoonieburn
Other services in Scoonieburn
Scoonieburn questions
What happens after I send photos?
We check the damage, the material and your postcode, then reply with a quote and the next dates we have.
Do you come to Scoonieburn?
Yes, we do. Repair technicians travel to Scoonieburn from across the region, and the price is the same as everywhere else.
Will the new finish last?
A well-prepared finish lasts a long time if it’s looked after. Gentle cleaning, no suction mats.
How do I book?
A close-up, a wider photo and your postcode. After that, we just agree a date.
What happens if you find more damage?
If we find something the pictures didn’t show, we explain it first. The price only changes if you agree.
Will it make a mess?
No. The work area is masked and covered, and we take our waste away with us.
Can you make a coloured bath white?
Yes. Coloured baths can be resurfaced in white, and the basin and toilet can be done too.
Can a failed resurfacing be redone?
Normally, yes. We strip the failing coating and resurface it properly. Tell us about it when you ask for a quote.
Common problems we fix in Scoonieburn
A dull surface stains and holds dirt, and scrubbing it wears it down further. At that stage, resurfacing is the fix.
It’s worth getting a quote if you see:
- Worn patches where water runs and sits
- Brown or grey marks that do not clean off
- A dull, rough surface that won’t come clean
- A period or roll-top bath worth keeping
Before booking anyone
- What happens if the damage is worse than the pictures show
- Who will actually do the work
- What protection goes down before work starts
- Whether the colour is mixed to match
DIY repairs versus a professional job
For a hairline mark somewhere you’ll never see, a kit may be enough. For damage in plain view, cracks, holes or rust, or coloured finishes, a professional repair is worth it.
If you’ve already tried a DIY fix, that is fine. We remove the old filler and start again, so it doesn’t stop a professional repair. It does add a little time, so tell us about it when you send photos.
Landlords, agents and businesses in Scoonieburn
We regularly price jobs from inventory or check-out photos. You can have a price before you arrange access, and we can arrange access with the tenant directly if that helps.
Builders use us to fix snagging damage before handover, so there’s no need to replace a damaged item at the last minute. Several plots can be done in one visit.
How it works
There’s not much you need to do on the day. Show us the job, point us to the room, and we’ll get on with it. The job generally runs to the best part of a day.
- The room is masked, protected and ventilated.
- Next we degrease the bath and fix chips and rust spots.
- We prepare the surface and apply a bonding primer.
- We spray on the new enamel finish in several coats.
- Once cured, normally by the next day, the bath is ready.
Getting ready for the visit
- Have a window or extractor fan available
- Ensure the area is dry
- Point us to the nearest place to park
Getting a price
Getting a price is easy: take a close-up of the damage and a picture from further back, send them to us with your postcode, and we will reply with a fixed quote. There is no charge for the quote and no obligation.
Advice
Looking after it afterwards
A little care keeps the finish looking good. Our advice:
- A dripping tap should be fixed promptly
- Don’t leave bottles, razors or sponges standing on the surface
- Leave the bath for the full curing time before using it
- Avoid suction-cup mats
Wipe the bath dry after use where you can, especially in hard water areas, and rinse off any bath products.
Avoid scrubbing a dull bath with abrasive cleaners. It removes more of the surface.
Repair or replace: which is better?
There are times replacing is better: if the bath is cracked through, if you want a different size or shape, or if you are refitting the whole room anyway. In most other cases, resurfacing is the better choice. Resurfacing from £350, with every job priced individually. Set against the cost of replacement, repairing generally costs far less, because nothing has to be taken out, refitted or made good. The quote lists exactly what you are paying for.
What you get with us
- One visit for most repairs
- A fixed quote before you book
- One price list for the whole UK
- Everything repaired in place
Take a look at our prices page or resurfacing vs replacement cost guide.
About our accreditations · Every repair comes with a one-year guarantee.
