Perth and Kinross · Scotland

Bath and surface repairs in PH2

We travel to every part of the PH2 postcode district, which takes in Scone, Bridge of Earn and Errol. Everything is repaired in place, with a one-year guarantee.

How bath repair works in PH2

Whatever the damage, the aim is the same: a repair that’s smooth, sound and hard to spot. We prepare the area properly, fill and shape it, then match the colour and gloss so it sits flush with the rest of the bath. We’re often asked to fix a chip where the taps sit and rust spots around the plughole, on cast iron enamel, acrylic and roll-top & freestanding.

Visits start with a quick look at the job together, so you know exactly what we are doing. Then the area is sheeted and masked and the work begins. It normally takes a morning or an afternoon, and we will tell you if anything changes.

  1. First, the area is cleaned and any loose enamel or rust is removed.
  2. Next we fill the damage and sand it smooth and level.
  3. The colour is mixed on the spot to match your bath.
  4. Finish coats go on, then the repair is polished to blend in.
  5. The repair is left to cure, and most baths can be used the day after.

What it costs in PH2

Our bath repair starts from £95. Our prices are the same across the UK, so there is no premium for PH2. What changes the price is the job itself: the material, the amount of damage and how many items.

What you get with us

  • Dust sheets down, tidy finish
  • CHAS and Constructionline accredited
  • We’ll tell you if it’s not worth repairing
  • No need to remove anything

Getting a price

Getting a price is easy: snap the damage close up and then the whole item, send them to us with your postcode, and you will get a fixed quote back. There’s no charge for the quote and no obligation.

Around Scone

Around Scone, we work in homes near North Inch and United Free Church. The closest station to Scone is Perth station, roughly 2.4 miles south-west of the centre. Well-known places in the area include Scone Palace (1.4 miles west) and Perth Royal Infirmary (1.4 miles south). Not far away are Kinnoull Hill.

What affects the price in PH2

Prices start from £95. Each job gets its own fixed price. This is what makes a difference:

  • Whether old repairs or coatings need taking off
  • Access to the area
  • How many items we do on one visit
  • What kind of damage it is

A repair typically costs much less than people expect, especially compared with replacing and refitting. Send photos and we’ll give you the exact figure.

Send pictures for a quote

You can take the photos on your phone. Just ensure we can see:

  • Daylight if possible, and no flash reflection
  • Details of any past repairs
  • A close-up of the damage, in focus
  • The postcode, so we can plan the visit

Upload pictures of the damage and a wider shot of the whole item, and tell us you’re in PH2, and we’ll reply with a fixed quote.

Different materials, different repairs

Acrylic

Acrylic baths are moulded sheet reinforced underneath. There’s no rust, but cracks, holes and scratches happen, and a crack only stays repaired if it’s supported underneath.

Composite and resin

Composite baths are dense and solid, and frequently freestanding. Chips and scratches are filled and matched, just like other baths.

Looking after it afterwards

A little care keeps the finish looking good. Our advice:

  • Do not leave a fresh chip for long
  • Give the bath a quick rinse after use
  • Put a towel in the bath if you are working above it
  • Avoid scourers, wire wool and gritty cream cleaners

Use gentle, non-abrasive cleaners and avoid dropping heavy items on the repaired area. Deal with new chips early, before rust sets in.

A chip on a metal bath shouldn’t be left. Once water reaches the metal, rust begins, turning a quick repair into a bigger one.

Why repair rather than replace?

A new bath brings a chain of other jobs: tiles along the rim normally crack when it comes out, a new panel is often needed, and a plumber has to disconnect and reconnect everything. A repair skips all of it.

Comparing quotes

  • When it can be used again
  • How the room is protected while they work
  • Whether they match the colour on site
  • What happens if the damage is worse than the pictures show

For landlords and businesses

We carry out planned and one-off repairs for housing associations and facilities teams. Repairing in place avoids the disruption of a replacement, which is easier on the people living there.

For anyone letting property in or around PH2, we will quote for several properties at once. Just send pictures for each address and we will price them together.

FAQs for PH2

Does someone need to be in?

Yes. The technician needs access to the room for the visit, at a time that suits you.

What do you need from me?

Some photos, your postcode and how to reach you. On the day, access to the room.

How invisible is a bath repair?

On a glossy bath, you’ll struggle to find it. On worn enamel, it can look shinier than the rest.

Is it OK to have pets in the house?

On the day, the room should be kept clear of pets and children.

Do you cover the entire of Perth and Kinross?

All of Perth and Kinross, and the rest of the UK. Travel is included in the price.

When can you do it?

That depends on our diary for your area. Send pictures with your postcode and we will reply with the earliest dates.

Is there a call-out fee?

No. Our quotes include travel, with the same prices everywhere we work.

CHAS accredited contractor and Constructionline logos SafeContractor, SMAS Worksafe and Builder’s Profile logos

About our accreditations · Every repair comes with a one-year guarantee.

Read what customers say about us on Trustpilot.