Perth and Kinross · Scotland
Bath chip & crack repair in Stormontfield, Perth and Kinross
Local bath repair for Stormontfield: a fixed quote from photos, a tidy visit and a one-year guarantee.
- Repairs from £95
- Deep scratches in acrylic
- Damage beneath the taps
How we handle bath repair in Stormontfield
Most of our bath repairs take a few hours, and the bath is back in use the day after. There’s no need to book a plumber or tiler, because the bath does not move. If you are dealing with a chipped rim or side and damage beneath the taps, we can help, whatever the material.
You get a one-year guarantee, the same in Stormontfield as everywhere else we work.
- Location
- Stormontfield (PH2)
- Area hub
- Perth and Kinross
- Cover
- A year, on every repair
- Quote
- From £95. Free and fixed, from your photos
- Call
- 0345 017 0787
- Updated
- 23 October 2026
What we do, step by step
You don’t need to empty the room beforehand. We bring everything we need with us, lay protective sheets and get going once we have agreed what we are doing. Most jobs take a morning or an afternoon, and you can get on with other things while we’re there.
- Dust sheets and masking go down around the bath.
- We clean, key and degrease the damage.
- We fill it, let it set, then sand it flush.
- Colour and gloss are matched to the surrounding surface.
- We tidy up and tell you when the bath can be used, usually the next day.
How to prepare
- Tell us about parking, stairs or access
- Let the surface dry out before the visit
- Point us to the nearest place to park
How to get a price
For most jobs, pictures are all we need to give you a price. Add a line about what happened and your postcode, and we’ll send back a fixed quote and some dates.
Advice
Different materials, different repairs
Acrylic
An acrylic bath is a moulded sheet strengthened from below. They don’t rust, but they can crack, scratch or be holed, and a crack only stays repaired if it’s supported underneath.
Pressed steel
Steel baths are lighter than cast iron, but have a similar enamel surface. Chips rust quickly on steel, especially around the waste, so repair chips early.
DIY repairs versus a professional job
What a professional repair adds is preparation, colour matching and finishing. We prepare the area properly, mix the colour on site and polish the finish to match, and the work is guaranteed.
If you do try a kit, read the instructions carefully, make sure the area is clean and completely dry, and give it the full curing time. If it does not work out, we can still repair it properly.
Stormontfield and nearby
Stormontfield is about 3 miles north of Perth, in Perth and Kinross. Whether you’re in the middle of Stormontfield or on the outskirts, we offer exactly the same service: fixed prices, tidy work and a one-year guarantee. Our repair technicians cover 107 places in Perth and Kinross, from the larger towns to small villages. Our nearest city page is Edinburgh, about 36 miles away.
Every address in PH2 is within our area. Close by, we cover Luncarty (1 mile west), Guildtown (2 miles north-east), Stanley (2 miles north), Tulloch (3 miles south) and Scone (3 miles south-east). Larger places within reach include Perth (3 miles south), Blairgowrie and Rattray (11 miles north-east), Auchterarder (14 miles south-west), Letham (3 miles south), Alyth (15 miles north-east) and Coupar Angus (10 miles north-east).
What’s near Stormontfield
Our customers here include homes close to Bertha Park High School, among other places. The nearest railway station is Perth station, roughly 3.9 miles south of the centre. Nearby you’ll also find Murray Royal Hospital (3.5 miles south) and St John's Shopping Centre (3.6 miles south). For a walk, there is Kinnoull Hill.
What else we do in Stormontfield
Looking after it afterwards
Simple care helps the repair last. Our advice:
- Rinse it down after each bath
- Keep metal cans and razors off the surface
- Check that an acrylic bath doesn’t move when you stand in it
- Get any new chip repaired before it rusts
For the first few days, keep heavy bottles off the repaired spot. After that, normal gentle cleaning is fine without abrasive products.
Tape over a fresh chip or crack until it’s repaired, so water cannot get in. Remove it before the repair.
When to call us in Stormontfield
Heavy toiletries are the biggest single cause of chips, with dropped shower heads close behind. Fittings cause damage too: water collects there, so chips nearby rust quickly.
People typically call us after spotting one of these:
- A failed DIY repair that’s discoloured or lifting
- Cracks in an acrylic bath
- Impact holes in acrylic
- Chips along the edge of the bath
Comparing quotes
- Whether the colour is mixed to match
- How long it needs to cure
- How the room is protected while they work
- What happens if they find more damage
When a repair isn’t the answer
Honesty matters more than a booking, so here’s what a repair cannot fix:
- Cracks in acrylic we can’t reach from underneath
- Metal that has corroded all the way through
- A bath that flexes because its feet or cradle have failed (that needs fixing first)
If in doubt, send photos and we’ll say what we think.
Materials we repair
- Roll-top & freestanding
- Whirlpool & spa baths
- Cast iron enamel
- Pressed steel enamel
- Acrylic
Work for landlords and builders
Hospitality businesses can’t afford rooms out of action for long, so we keep visits short and tidy. We will fit around changeovers where we can.
We regularly work with letting and managing agents. Just send pictures, the address and how to get access.
Stormontfield questions
Can you match an avocado or pink bath?
Yes. We mix the colour on the day to match, including older coloured suites.
What do you need from me?
A close-up, a wider photo and your postcode. After that, we just agree a date.
How invisible is a bath repair?
The goal is a repair that blends in. The rest of the bath’s condition makes a difference, and we’ll tell you what to expect.
Does someone need to be in?
Yes. We need access to the room while we work, at a time we agree with you.
Can you repair a failed DIY repair?
Yes. We remove the old filler and start again. Mention it when you send photos.
Can you quote from photos?
In nearly every case. If photos do not show enough, we will ask for another angle.
It’s been repaired before. Can you still fix it?
Normally, yes. The old repair comes out first.
Will the price change on the day?
Your quote covers the damage in the photos. Anything extra is discussed before we begin.
Why repair rather than replace?
Cast iron baths in particular are worth repairing: getting one out, particularly from an upstairs bathroom, is a big job, and replacing like for like isn’t cheap. Repairing it leaves it where it is. Prices start from £95. The price depends on the type and amount of damage, what it’s made of and how many items we do on one visit. We give a fixed quote from your pictures, so there are no surprises on the day.
Why us?
- Colour-matched on site
- We leave the room as we found it
- Accredited with CHAS, Constructionline and SafeContractor
- We’ll tell you if it’s not worth repairing
Take a look at our prices page and bath cost comparison.
About our accreditations · Every repair comes with a one-year guarantee.
