Stockton-on-Tees · England
Bath re-enamelling & resurfacing in High Leven, Stockton-on-Tees
Bath re-enamelling in High Leven without the cost of replacing. Get a fixed price from your pictures, then book a visit.
- Resurfacing from £350
- An original cast iron bath that needs restoring
- Staining under the taps and around the waste
Bath re-enamelling in High Leven, done in place
We resurface cast iron, steel and acrylic baths, including roll-tops and period baths. The finish is sprayed on in several coats over a bonding primer, after the bath has been cleaned, repaired and keyed. We are often asked to fix an outdated colour you’d like to change and a period or roll-top bath worth keeping, in acrylic baths, Victorian roll-tops and cast iron baths.
All our work is covered by our one-year guarantee.
- Area
- High Leven (TS17, TS15)
- Area hub
- Stockton-on-Tees
- Warranty
- 12 months on all our work
- Price
- From £350. Free and fixed, from your pictures
- Phone
- 0345 017 0787
- Page updated
- 23 October 2026
How it works
We agree an arrival time beforehand. Once we are there, the work takes most of the day in most cases. We leave the room clean and ready to use once it has cured.
- We sheet, mask and ventilate the room.
- We remove the old silicone and deep clean the bath.
- We repair chips, rust spots and pitting.
- We key the bath and apply a bonding primer.
- The new finish is sprayed on in several coats and left to cure.
Before we arrive
- Mention if the room is upstairs or in a flat
- Let the surface dry out before the visit
- Clear the area around the damage
How to get a price
Getting a quote takes a couple of minutes: photograph the damage, then the whole bath, include your postcode and send them over. What comes back is a fixed price, not a guess.
Related advice
Places near High Leven
More services for High Leven
Questions from High Leven
Will the price change on the day?
The price is fixed for what the photos show. Anything extra is discussed before we begin.
Do you work in High Leven?
Yes. We work across the UK and travel to High Leven and the rest of Stockton-on-Tees. Send photos and we’ll quote, or call 0345 017 0787.
Do you need to take the bath out?
No. It’s re-enamelled where it stands, so nothing else is disturbed.
What information do you need?
Send pictures through the quote form or call 0345 017 0787.
Which areas do you work in?
We work UK-wide, so High Leven is covered. Our prices are the same everywhere.
How much does bath re-enamelling cost in High Leven?
Prices start from £350. Because every job differs, we price from photos. You’ll get a fixed figure before booking.
Can landlords book you?
Yes. We work for landlords, agents, builders and businesses as well as householders across Stockton-on-Tees.
Do the materials smell?
There can be some smell while we work. It clears as the materials cure.
DIY repairs versus a professional job
For a hairline mark somewhere you’ll never see, a kit may be enough. For anything you look at every day, anything that has rusted, cracked or holed, or anything on a coloured surface, a professional repair is worth it.
What a professional repair adds is preparation, colour matching and finishing. We prepare the area properly, mix the colour on site and polish the finish to match, then guarantee it for a year.
When we would advise against a repair
Not everything can be repaired, and we would rather say so up front. Repairs won’t solve:
- A bath split right through the body
- Acrylic that moves when you stand in it
- Holes rusted through the metal
Send us pictures and we’ll tell you honestly before you book.
Materials we repair
- Cast iron baths
- Basins & shower trays
- Pressed steel baths
- Acrylic baths
- Victorian roll-tops
How to look after the repair
Once the work has cured, treat it gently:
- Dry the bath after use to stop limescale
- Have chips seen to early
- Store bottles off the bath
- Rinse off hair dye, oils and bath bombs right away
Use mild, non-abrasive cleaners, do not use suction bath mats, and keep bottles and razors off the surface.
Rust spots on a worn bath get worse with time and make the job bigger. It’s simpler to resurface before they spread.
Landlords, agents and businesses in High Leven
If you manage property in High Leven, we can repair and quote for several addresses together. Send photos for each one and we’ll price them together.
Rental properties take more wear, and replacing things at every changeover adds up. A repair between tenancies is a cheaper way to keep the property in good order.
About High Leven
High Leven is about 1 mile south of Ingleby Barwick, in Stockton-on-Tees. Our repair technicians come to homes and businesses in High Leven and the surrounding area, so nothing has to leave your home. We cover all 31 towns and villages in Stockton-on-Tees. We work right across the region, from High Leven to Newcastle upon Tyne (36 miles away).
Here we cover the TS17 and TS15 postcode area. Whether you live on Melandra Road, High Cross Road and Sober Hall Avenue or a nearby road, a technician can come to you. High Leven is on the A1044, which makes it straightforward to reach. Neighbouring places we cover include Low Leven (1 mile south-west), Ingleby Barwick (1 mile north), Levendale (1 mile west), Eaglescliffe (2 miles north-west) and Egglescliffe (2 miles north-west). Further out, we also cover Stockton-on-Tees (5 miles north), Billingham (7 miles north), Thornaby-on-Tees (3 miles north), Elm Tree Farm (5 miles north), Fairfield (5 miles north-west) and Wynyard (9 miles north).
What’s near High Leven
Around High Leven, we work in homes near Ingleby Mill Primary School, St. Francis of Assisi Church of England and Ingleby Manor Free School & Sixth Form and the streets around them. High Leven’s nearest station is Yarm station, about 1.9 miles south-west of the centre. Further afield, we also cover the area around Newham Grange Farm Museum (3.9 miles north-east) and Carter Bequest Primary Care Hospital (4.1 miles north-east).
Repairs by material
Roll-top and period baths
We can resurface a roll-top inside and out, and the outside can be refinished too.
Cast iron
A cast iron bath is heavy enough that most people never want to move it. The enamel is the part that wears or chips, and that’s what we repair.
Signs you need bath re-enamelling in High Leven
Enamel’s shine is only skin deep, and abrasive cleaning slowly wears it away. Eventually the surface turns porous and stains.
Typical reasons for a call-out include:
- Brown or grey marks that do not clean off
- A bath that stays dull however much you clean it
- Thin, worn enamel in places
- Lots of chips and rust spots
What to look for in a quote
- How your room will be protected
- What happens if the damage is worse than the pictures show
- Is the price fixed, and does it include VAT?
- Who will actually do the work
How we price bath re-enamelling
Resurfacing from £350. We give every job a fixed quote from pictures. These are the things that affect it:
- Previous DIY repairs that have to come out
- The size and number of damaged areas
- What kind of damage it is
- The material
We do not add extras on the day. What we quote from your photos is what you pay, unless the damage turns out to be different, in which case we talk to you first.
Quotes from your photos
Before you send photos, these tips help us give you a firm price:
- A clear, close picture of the problem area
- Any details about the material
- A coin beside the damage so we can judge size
- Details of any past repairs
Most clients in High Leven get their price from photos. Tell us what happened and where you are, and we will reply with a fixed quote and the earliest dates we have.
About our accreditations · Every repair comes with a one-year guarantee.
