Bath and North East Somerset · England
Bath Re-enamelling in Lower Strode
Full bath re-enamelling and resurfacing for homes and businesses in Lower Strode and across Bath and North East Somerset. Send photos for a free, fixed quote.
- Resurfacing from £350
- Wear marks under the taps
- A period or roll-top bath worth keeping
How it works
On the day itself, there is little for you to do. Show us the job, point us to the room, and we’ll take it from there. Most visits take the best part of a day.
- We sheet, mask and ventilate the room.
- We remove the old silicone and deep clean the bath.
- Chips, rust and pitting are repaired.
- The surface is keyed and primed for the new finish.
- Several coats of finish are sprayed on, then it cures.
Preparing for the visit
- Have somewhere for us to park nearby if possible
- Tell us if there are stairs or a lift
- Mention any parking restrictions or tricky access
Getting a price
For a price in Lower Strode, the easiest route is pictures: a close-up, a wider shot and your postcode. You’ll get a fixed quote with dates to choose from.
Advice
About our bath re-enamelling in Lower Strode
Re-enamelling is a one-day job for most baths, and you can use the bath the following day. Taps, tiles, panels and plumbing all stay in place. We regularly repair basins & shower trays, cast iron baths and Victorian roll-tops, and the jobs we see most are thin, worn enamel in places and several chips and rust patches.
The work is covered for a year after we finish. Just call us if there is a problem and we’ll come back.
- Area
- Lower Strode (BS40)
- Area hub
- Bath and North East Somerset
- Cover
- 12 months on all our work
- Quote
- From £350. Free, fixed price from pictures
- Call
- 0345 017 0787
- Updated
- 23 October 2026
What we are called out for in Lower Strode
Hard water speeds up the wear, and gritty cleaners are the worst culprits.
Contact us if you’ve noticed any of these:
- A bath that stays dull however much you clean it
- A peeling or bubbling previous coating
- An outdated colour you’d like to change
- Staining under the taps and around the waste
What to look for in a quote
- What happens if the damage is worse than the photos show
- How long it needs to cure
- If travel is included in the price
- Whether they match the colour on site
Honest limits
A repair is not always the answer, and we will tell you before we start. Repairs won’t solve:
- Damage hidden under a previous coating, until it’s stripped back
- A bath that’s rusted through
- A cast iron or steel bath that is cracked right through
Not sure? Send photos and we will give you a straight answer before booking.
Surfaces we repair
- Cast iron baths
- Acrylic baths
- Victorian roll-tops
- Pressed steel baths
- Basins & shower trays
For landlords and businesses
Rental properties take more wear, and replacing items every time a tenant leaves is expensive. A repair between tenancies is a cheaper way to keep the property in good order.
Letting agents often send us photos straight from the inventory. You can have a price before you arrange access, and we liaise with tenants about access if you’d like us to.
Why repair rather than replace?
A new bath means a plumber, removing a heavy bath, making good the walls and tiles and days without a bathroom. Resurfacing gives the bath a new finish with the bath left where it is. Resurfacing from £350, with every job priced individually. What it costs depends on the type and amount of damage, what it’s made of and how many items we do on one visit. You get a fixed price from your pictures, so you know the cost before you book.
Why Lower Strode clients choose us
- Accredited with CHAS, Constructionline and SafeContractor
- We come to you, anywhere in the UK
- One price list for the entire UK
- Honest advice, even when it means no job
See our prices page or resurfacing vs replacement cost guide.
What your bath is made of matters
Acrylic
We resurface acrylic baths as well, using a system that bonds to acrylic. The bath needs to be firm and well supported for the finish to last.
Cast iron
Re-enamelling suits cast iron baths perfectly. They’re built to last, and only the surface wears, so a new finish makes them look new again.
Also near Lower Strode
More services for Lower Strode
Prices and what affects them
Prices start from £350. You won’t pay by the hour. The price depends on:
- How many items we do on one visit
- What the surface is made of
- The type of damage
- Whether old repairs or coatings need taking off
There are no surprise extras on the day. What we quote from your pictures is what you pay, and if the damage turns out to be different, we discuss it before starting.
Send pictures for a quote
It only takes a minute to photograph the damage. Try to send:
- One sharp close-up of the damage
- Any details about the material
- Details of any past repairs
- A wider photo showing the entire bath
No survey visit is needed: we price from pictures. Send them through the quote form, or call 0345 017 0787 if you’d rather talk it through, and you’ll get a fixed figure back.
Covering Lower Strode
Lower Strode is about 7 miles south-east of Nailsea, in Bath and North East Somerset. We agree a date that works for you, and we’ll give you an arrival time in advance, so there is no waiting around. Lower Strode is one of 136 towns and villages in Bath and North East Somerset where we work.
We cover every part of the BS40 postcode area. We also travel to Regil (1 mile north), Nempnett Thrubwell (1 mile south-west), Hounsley Batch (1 mile north), Chew Stoke (1 mile east) and Butcombe (2 miles west). We also work in nearby towns such as Bath (13 miles east), Keynsham (8 miles north-east), Bathwick (14 miles east), Walcot (13 miles east), Westmoreland (12 miles east) and Kingsmead (13 miles east).
Around Lower Strode
In Lower Strode, that means homes near St James, Chew Stoke Church School and Chew Valley School and the streets around them. Other landmarks nearby include Oval enclosure (3.8 miles east) and Barrow Hospital (4.7 miles north). Not far away are Litton Reservoirs and Knowle Hill.
Can I fix it myself?
For a hairline mark somewhere you’ll never see, a kit may be enough. For damage in plain view, cracks, holes or rust, or coloured finishes, it’s worth having it done properly.
If you are set on a kit, follow its instructions closely, ensure the area is clean and completely dry, and give it the full curing time. If it fails, we can still put it right.
Lower Strode: your questions answered
Will you leave a mess?
We protect the room with dust sheets and masking first, and tidy up before we leave.
Will there be fumes?
Some odour is normal while we spray, which is why we ventilate the bathroom. It clears as the finish cures.
How long does re-enamelling last?
A well-prepared finish lasts a long time if it’s looked after. Avoid abrasive cleaners and suction mats.
Do I have to be there?
Yes. The technician needs access to the room for the visit, at a time that suits you.
Do you resurface freestanding baths?
Yes. Inside and out.
What does bath re-enamelling cost?
Resurfacing from £350. We give a fixed quote based on pictures of the damage. Send a close-up and a photo of the entire item and your postcode.
Do you work for landlords and businesses?
Yes. We work for landlords, agents, builders and businesses as well as householders across Bath and North East Somerset.
Can you change the colour of my bath?
Yes. Coloured baths can be resurfaced in white, and we can do the rest of the suite as well.
About our accreditations · Every repair comes with a one-year guarantee.
