Wiltshire · England
Bath re-enamelling & resurfacing in Milford, Wiltshire
Local bath re-enamelling for Milford: photo quotes, tidy work and a year’s guarantee.
- Resurfacing from £350
- A roll-top that is seen better days
- A coloured bath you want in white
Keeping it looking good
It’s all simple stuff:
- Wipe the bath dry after use in hard water areas
- Do not let dyes or oils sit on the finish
- Don’t leave bottles, razors or sponges standing on the surface
- Respect the curing time we give you
Dry the bath after use if possible, particularly with hard water, and rinse away any product left on the surface.
The longer worn enamel is left, the rougher it gets, and rust spots spread under the surface. Resurfacing sooner means less repair work first.
How we handle bath re-enamelling in Milford
Re-enamelling works especially well on cast iron and steel, and we can resurface acrylic baths as well. You end up with a smooth, glossy surface. If you’re dealing with wear marks under the taps and a dull, rough surface that won’t come clean, we can typically put it right, whatever the material.
Big or small, it’s backed by a one-year guarantee in Milford and across Wiltshire.
- Location
- Milford (SP1, SP2, SP5)
- Region
- Wiltshire
- Warranty
- 12 months on all our work
- Price
- From £350. Free, fixed price from pictures
- Telephone
- 0345 017 0787
- Page updated
- 23 October 2026
Landlord and trade work in Milford
We are used to working with agents and managing companies. Just send pictures, the address and how to get access.
Rented homes see more wear and tear, and replacing items every time a tenant leaves is expensive. A repair between tenancies is a cheaper way to keep the property in good order.
What we do, step by step
A typical visit goes like this: we arrive on time, sheet and mask the area around the job, carry out the work and tidy away. Plan for most of the day from start to finish. Before leaving, we tell you how long to leave it and how to look after it.
- The bathroom is protected and ventilation set up.
- We remove the old silicone and deep clean the bath.
- We repair chips, rust spots and pitting.
- We key the bath and apply a bonding primer.
- Several coats of finish are sprayed on, then it cures.
How to prepare
- Point us to the nearest place to park
- Tell us about any previous repairs or coatings
- Tell us about parking, stairs or access
Ask for a price
A quote takes minutes to ask for: photograph the damage, then the entire bath, add your postcode and send them to us. You’ll get a fixed quote, not an estimate.
Read more
Covering Milford
Milford is about 1 mile south-east of Salisbury, in Wiltshire. We agree a date that works for you, and we’ll give you an arrival time in advance, so you are not left waiting in all day. We work in 425 places in Wiltshire, from the larger towns to small villages. We work right across the region, from Milford to London (about 79 miles away).
Every address in SP1, SP2 and SP5 is covered, from the main roads to the quietest streets. That includes homes on Cow Lane, Salt Lane and The Avenue. Neighbouring places we cover include Bugmore (1 mile south-west), Laverstock (1 mile north-east), Salisbury (1 mile north-west), Harnham (1 mile south-west) and Britford (1 mile south). We also work in nearby towns such as Amesbury (7 miles north), Old Sarum (3 miles north), Bulford (9 miles north), Wilton (4 miles west), Tisbury (13 miles west) and Durrington (9 miles north).
What’s near Milford
Locally, our jobs take us to homes close to Bishop Wordsworth's Church of England Grammar School, Salisbury Sixth Form College and Corn Exchange, among other places. Also close by are Church of St Martin (under half a mile south-west), St Martin's CofE Voluntary Aided Primary School (less than half a mile north-west) and The Railway Inn/The Dust Hole (under half a mile south-west). For rail, the closest station is Salisbury station, roughly 1 mile west. Other landmarks nearby include Harvard Hospital (1.2 miles south-west) and Clarendon Palace (1.8 miles east). The countryside around Milford includes Harnham Hill.
- Local facilities include Salisbury (0.6 miles west)
What your bath is made of matters
Roll-top and period baths
We can resurface a roll-top inside and out, and the outside can be refinished too.
Cast iron
Re-enamelling suits cast iron baths perfectly. The body lasts for generations; only the enamel wears, so a new finish makes them look new again.
What affects the price in Milford
Resurfacing from £350. We don’t charge extra for travel to Milford. The price comes down to:
- The material and finish
- What kind of damage it is
- How easy the damage is to reach
- How many items we do on one visit
Set against the cost of replacement, a repair is normally a fraction of the price, because nothing has to be taken out, refitted or made good. Your fixed quote shows exactly what’s included.
How to get a fixed quote
The better the pictures, the more accurate the price. Here’s what helps:
- Details of any past repairs
- A coin beside the damage so we can judge size
- Good light, ideally daylight, without flash glare
- A wider photo showing the whole bath
Email us a picture of the damage and a wider shot of the whole item, and tell us you are in Milford, and we’ll come back with a fixed quote.
What else we do in Milford
When we would advise against a repair
We will always be straight with you, so here’s what a repair will not do:
- Plumbing leaks, which need a plumber
- Acrylic that moves when you stand in it
- Damage hidden under a previous coating, until it’s stripped back
Send us photos and we’ll tell you honestly before you book.
Materials we repair
- Basins & shower trays
- Pressed steel baths
- Acrylic baths
- Victorian roll-tops
- Cast iron baths
Questions from Milford
Can you re-enamel a roll-top bath?
Yes. We can do the inside and outside if you’d like.
Is the work guaranteed?
Yes, for a year. If there’s a problem with the work in that time, we come back and put it right.
Is it messy?
Very little mess: we sheet and mask everything nearby, and we leave the room clean.
Can you change the colour of my bath?
Yes, white is the usual choice. Tell us what you’d like when you ask for a quote.
Does the bath have to be removed?
Not at all. We work on the bath in place, with the room masked and ventilated.
Do you hold any accreditations?
Yes. Our accreditations include CHAS, Constructionline and SafeContractor. See our accreditations page for the full list.
What happens after I send pictures?
We come back with a fixed quote. There’s no obligation to book.
What areas do you cover?
We cover the entire UK, including Milford and the rest of Wiltshire. Just include your postcode and we’ll offer you dates.
Common problems we fix in Milford
By the time a bath is a few decades old, it may have a mix of issues: dull areas, chips, rust and staining. Resurfacing sorts them out together.
Keep an eye out for these signs:
- Chips and rust in more than one place
- An original cast iron bath that needs restoring
- Wear marks under the taps
- A bath in a colour that no longer suits
What your quote should include
- What prep work is covered
- Whether the price covers travel
- Aftercare advice
- When it can be used again
Repair or replace: which is better?
There are times replacing is better: if the bath is cracked through, if you want a different size or shape, or if you’re refitting the whole room anyway. In most other cases, resurfacing is the better choice. Our bath re-enamelling starts from £350. Rather than charging by the hour, we price the entire job up front. Damage, material and access decide it, and doing several items at once reduces it.
Why book with us
- One price list for the entire UK
- Colours mixed by hand to suit your surface
- Everything repaired in place
- We come to you, anywhere in the UK
Read our prices page and guide to resurfacing and replacement costs.
About our accreditations · Every repair comes with a one-year guarantee.
