Pembrokeshire · Wales
Bath re-enamelling & resurfacing in The Valley, Pembrokeshire
We travel to The Valley for full bath re-enamelling and resurfacing. Nothing is taken out, and the work is guaranteed.
- Resurfacing from £350
- Wear marks under the taps
- Chips and rust in more than one place
How it works
On the day, the technician arrives at the agreed time, protects the room with dust sheets and masking and gets started. The job generally takes a full day. We clean up when we are done and let you know when you can use it again.
- The bathroom is protected and ventilation set up.
- We remove the old silicone and deep clean the bath.
- Chips, rust and pitting are repaired.
- The surface is keyed and primed for the new finish.
- The new finish is sprayed on in several coats and left to cure.
Getting ready for the visit
- Avoid using the area for a few hours before we arrive
- Tell us about parking, stairs or access
- Mention any earlier repairs or resurfacing
Ask for a price
A quote takes minutes to ask for: photograph the damage, then the whole bath, include your postcode and send them over. You will get a fixed quote, not an estimate.
Related advice
How we handle bath re-enamelling in The Valley
After cleaning, repairing and priming, we spray on the new finish. The preparation is what makes it last, and we take our time over it. Typical jobs include lots of chips and rust spots and brown or grey marks that don’t clean off, in Victorian roll-tops, pressed steel baths and acrylic baths.
Your repair is guaranteed for a year, as with every job we do.
- Location
- The Valley (SA69)
- Area hub
- Pembrokeshire
- Guarantee
- A year, on every repair
- Price
- From £350. Fixed and free, based on photos
- Phone
- 0345 017 0787
- Page updated
- 23 October 2026
Prices and what affects them
Prices start from £350. A fixed quote means you know the cost before booking. We look at:
- How hard the colour is to match
- What kind of damage it is
- Access to the area
- The size and number of damaged areas
Instead of hourly rates, we price the entire job up front. Damage, material and access decide it.
Getting a price from photos
Two or three clear photos are normally enough. Try to include:
- What it’s made of, if you know
- One picture of the whole bath
- One sharp close-up of the damage
- Any earlier repairs or coatings
The quickest way to a price is to send two or three pictures using our quote form or call us. We’ll tell you honestly if a repair is the right fix.
Honest limits
Some jobs aren’t right for a repair, including:
- A bath split right through the body
- A bath that is rusted through
- Anything hidden under an old coating, until we remove it
Not sure? Send photos and we’ll give you a straight answer.
Surfaces we repair
- Pressed steel baths
- Basins & shower trays
- Victorian roll-tops
- Cast iron baths
- Acrylic baths
Different materials, different repairs
Pressed steel
Pressed steel baths take a new finish well, once any rust has been treated. Steel frequently rusts by the plughole, so we check it carefully.
Roll-top and period baths
We can resurface a roll-top inside and out, and the outside can be refinished too.
Nearby places to The Valley
Also in The Valley
Aftercare tips
How the surface is treated afterwards matters:
- Wash away dyes and oils after use
- Fix dripping taps quickly
- Keep suction mats out of the bath
- Respect the curing time we give you
Wipe the bath dry after use where you can, and rinse away any product left on the surface.
Leave a peeling coating alone. Water gets under it and the damage spreads, so have it stripped and resurfaced.
Repair or replace in The Valley?
Replacement only makes sense in a few cases: a cracked-through bath, a change of size or shape, or a full refit. Otherwise, resurfacing generally wins. Resurfacing from £350, with every job priced individually. Set against the cost of replacement, repairing usually costs far less, because nothing has to be taken out, refitted or made good. The quote lists exactly what you are paying for.
What you get with us
- Colour mixed on the day to match
- Fixed prices from your photos
- Usually one visit, start to finish
- Honest advice, even when it means no job
Take a look at our prices page or guide to resurfacing and replacement costs.
Common problems we fix in The Valley
Frequently the bath has just had decades of use, with nothing wrong except the surface. Underneath, a cast iron or steel bath is typically as strong as ever.
Send us a picture if you notice any of these:
- An original cast iron bath that needs restoring
- Worn patches where water runs and sits
- Staining under the taps and around the waste
- A bath that stays dull however much you clean it
Before you book anyone
- Whether they match the colour on site
- When it can be used again
- The length of the guarantee and what it covers
- Whether a trained technician does the job
Our work in The Valley
The Valley is about 12 miles south-east of Haverfordwest, in Pembrokeshire. Clients in The Valley get the same service as everywhere else we cover: a fixed quote from your pictures, and a technician at your door on the day. Our repair technicians cover 223 places across Pembrokeshire.
Jobs in SA69 work the same way as everywhere else we cover. Neighbouring places we cover include Wooden (1 mile west), Pentlepoir (1 mile north-west), Hill (1 mile north), Saundersfoot (1 mile east) and Kingsmoor (1 mile north). We also work in nearby towns such as Haverfordwest (12 miles north-west), Milford Haven (13 miles west), Pembroke (9 miles west), Pembroke Dock (10 miles west), The Marsh (12 miles north-west) and Dinbych-y-Pysgod (3 miles south).
Landmarks near The Valley
Typical jobs here are in homes near Saundersfoot C.P. School, St Issell's Church and Woodridge Inn Hotel, among other places. The nearest railway station is Saundersfoot station, roughly 0.5 miles north. A little further out are Tudor Merchant's House Museum (3.2 miles south) and Hean Castle Motte (1.1 miles east). The countryside around The Valley includes Pentlepoir Hill.
Landlord and trade work in The Valley
Rental properties take more wear, and replacing items every time a tenant leaves is expensive. Repairing between tenants keeps the property presentable for less.
Housing associations and facilities teams use us for planned and reactive repairs in Pembrokeshire and across the UK. Repairing in place avoids the disruption of a replacement, which matters when someone is living in the home.
The Valley questions
How long will the bath be out of use?
Typically a day, then it’s ready to use the following day. Deeply pitted baths may need a second day.
Will the bath be moved?
Not at all. Everything is done in your bathroom, with the room masked and ventilated.
Can you redo someone else’s repair?
Yes, regularly. It can add a little time, which we include in the quote.
What happens after I send photos?
We look at the pictures and reply with a fixed quote and some dates. If anything’s unclear, we’ll ask for another photo.
Do I have to be there?
We need someone to let us in. You don’t need to watch us work.
What does bath re-enamelling cost?
Prices start from £350. The exact price depends on the damage, so we quote from pictures. You know the full cost before anything is booked.
Do you come to The Valley?
Yes. We cover the entire UK and come to The Valley and the rest of Pembrokeshire. Send us photos for a fixed quote, or call 0345 017 0787.
I’m a tenant. Can you help?
We can work for tenants, landlords or agents. Just make sure the landlord agrees.
About our accreditations · Every repair comes with a one-year guarantee.
