Wiltshire · England
Bath Re-enamelling for Upper Chicksgrove homes
Bath re-enamelling for Upper Chicksgrove, without a refit. Send us pictures for a fixed price, then book a visit.
- Resurfacing from £350
- Worn patches where water runs and sits
- A bath that stays dull however much you clean it
Honest limits
We would rather lose a job than do one that will not last, so these are the limits:
- Steel that has corroded right through
- An acrylic bath that flexes badly underfoot
- Damage hidden under a previous coating, until it’s stripped back
Send us photos and we will tell you honestly before booking.
Materials we repair
- Cast iron baths
- Acrylic baths
- Victorian roll-tops
- Pressed steel baths
- Basins & shower trays
Bath re-enamelling at your home in Upper Chicksgrove
Re-enamelling gives a worn bath a new glossy surface without a refit. It’s the answer when the whole bath is tired rather than one spot. If you are dealing with an old resurfacing that’s failing and several chips and rust patches, we can typically put it right, on acrylic baths, pressed steel baths and Victorian roll-tops alike.
You’re covered for a year from the day of the repair. Just call us if there is a problem and we’ll sort it.
- Location
- Upper Chicksgrove (SP3)
- Area hub
- Wiltshire
- Cover
- One year on every repair
- Price
- From £350. Fixed and free, based on pictures
- Telephone
- 0345 017 0787
- Last updated
- 23 October 2026
Repair or replace in Upper Chicksgrove?
A refit takes several trades and several days. Resurfacing is one technician, normally in a day, with the bath ready the following day. Resurfacing from £350, with every job priced individually. A repair is priced on what needs doing, not your postcode. You’ll see the full price before booking.
Why us?
- We leave the room as we found it
- Honest advice, even when it means no job
- Repair technicians who travel to you, UK-wide
- Colour mixed on the day to match
Take a look at our full price list and bath cost comparison.
When to call us in Upper Chicksgrove
Enamel wears gradually. Years of cleaning, hard water and hot baths dull the surface, starting where water runs and sits.
These are the problems we’re asked about most:
- A period or roll-top bath worth keeping
- Thin, worn enamel in places
- A peeling or bubbling previous coating
- Several chips and rust patches
What to look for in a quote
- Who turns up on the day
- What protection goes down before work starts
- Whether cleaning and preparation are in the price
- When it can be used again
DIY repairs versus a professional job
It’s tempting to reach for a kit, but the repairs we redo most frequently are DIY ones that have discoloured or lifted. Getting it right first time is usually cheaper.
A kit can be fine for a tiny mark out of sight. For anything you look at every day, anything that has rusted, cracked or holed, or anything on a coloured surface, a professional repair is worth it.
Work for landlords and builders
Letting agents often send us photos straight from the inventory. That means we can quote before you even visit the property, and we can arrange access with the tenant directly if that helps.
Rental properties take more wear, and replacing things at every changeover adds up. Repairing between tenants keeps the property presentable for less.
What bath re-enamelling costs
Prices start from £350. You’ll know the full cost before booking. We look at:
- How many items we do on one visit
- How many areas need work
- The type of damage
- How easy the damage is to reach
Compared with replacing, a repair is normally a fraction of the price, because there is no removal, plumbing or making good. The quote lists exactly what you are paying for.
How to get a fixed price
Before you send photos, a few simple things make all the difference:
- Good light, ideally daylight, without flash glare
- Your postcode, so we can check dates
- A close-up of the damage, in focus
- Any earlier repairs or coatings
Most customers in Upper Chicksgrove get their price from photos. Add a line about what happened and your postcode, and we will reply with a fixed quote and the earliest dates we have.
About Upper Chicksgrove
Upper Chicksgrove is about 11 miles south-east of Warminster, in Wiltshire. Our technicians come to homes and businesses in Upper Chicksgrove and nearby villages, so nothing has to leave your home. Our technicians cover 425 places across Wiltshire, from the larger towns to small villages.
Jobs in SP3 work the same way as everywhere else we cover. We also cover the places around Upper Chicksgrove: Tisbury (1 mile west), Ridge (1 mile north), Tuckingmill (2 miles west), Swallowcliffe (2 miles south) and Sutton Mandeville (2 miles east). Further out, we also cover Salisbury (11 miles east), Westbury (15 miles north-west), Warminster (11 miles north-west), Amesbury (14 miles north-east), Bugmore (11 miles east) and Milford (12 miles east).
Near you in Upper Chicksgrove
In Upper Chicksgrove, that means homes near The Compasses Inn and Church of St John the Baptist. The closest station to Upper Chicksgrove is Tisbury station, roughly 1.1 miles south-west of the centre. Nearby you will also find Old Wardour Castle (2.6 miles south-west). The countryside around Upper Chicksgrove includes Fonthill Lake and Swallowcliffe Down.
How the visit works
The work is clean and fairly quiet. Protection goes down first, then the work takes a full day. Before we leave, we explain the curing time and the aftercare.
- First we look the bath over and confirm the finish.
- Taps, tiles and the floor are masked off.
- The bath is degreased, repaired and keyed.
- We apply the primer and then the finish coats.
- We remove the masking, tidy up and give you the curing time.
Getting ready for the visit
- Keep children and pets away from the room on the day
- Point us to the nearest place to park
- Mention any earlier repairs or resurfacing
How to get a price
We price from photos so you don’t have to wait in for a survey. Use the quote form, or ring 0345 017 0787 to talk it through.
Related advice
Also near Upper Chicksgrove
Other services in Upper Chicksgrove
How to care for the repair
So the finish stays in good condition:
- Never use suction bath mats
- Use washing-up liquid and a soft cloth
- Fix dripping taps quickly
- Do not use the bath until it has fully cured
A quick rinse and wipe after use helps, especially in hard water areas, so limescale cannot build up.
On a worn bath, rust spots keep spreading, and each one adds to the preparation. Resurfacing before they spread keeps it simpler.
FAQs for Upper Chicksgrove
Is there any odour?
There can be some smell while we work, which is why we ventilate. It fades as everything cures.
How long is the bath unusable?
Most baths are done in a day and can be used the day after. We’ll confirm timings when we quote.
Can tenants book a repair?
We’re happy to deal with the tenant, landlord or agent. Just make sure the landlord agrees.
What if the damage is worse than the photos show?
We’ll show you and explain before doing anything extra. Nothing extra is done without your say-so.
Can you repair several things at once?
Of course, and it typically saves money. Send pictures of everything together and you’ll get one combined price.
Do you hold any accreditations?
We hold CHAS, Constructionline, SafeContractor, SMAS Worksafe and Builder’s Profile accreditations.
Can you price it without visiting?
In nearly every case. If photos don’t show enough, we will ask for another angle.
Can you make a coloured bath white?
Yes, white is the usual choice. Mention the colour you want when you send photos.
About our accreditations · Every repair comes with a one-year guarantee.
