Perth and Kinross · Scotland
Bath Re-enamelling in Errol
Our repair technicians come to Errol for full bath re-enamelling and resurfacing. Nothing is taken out, and the work is guaranteed.
- Resurfacing from £350
- Lots of chips and rust spots
- An original cast iron bath that needs restoring
Bath re-enamelling in Errol, done in place
The bath stays where it is, so the taps, tiles and plumbing aren’t touched. Most baths are done in one visit, and can be used again the following day. We work on cast iron baths, Victorian roll-tops and acrylic baths, and people most frequently call us about brown or grey marks that don’t clean off and several chips and rust patches.
You get a one-year guarantee, the same in Errol as everywhere else we work.
- Location
- Errol (PH2)
- County
- Perth and Kinross
- Warranty
- 12 months on all our work
- Quotes
- From £350. Fixed and free, based on photos
- Phone
- 0345 017 0787
- Updated
- 23 October 2026
Repairing versus replacing in Errol
When the bathroom is fine apart from the bath’s finish, re-enamelling is the least disruptive fix. Nothing else is disturbed. Resurfacing from £350, with every job priced individually. A repair generally costs much less than people expect, especially compared with replacing and refitting. Send pictures and we’ll give you the exact figure.
What you get with us
- Honest advice, even when it means no job
- Free fixed quotes from pictures
- One visit for most repairs
- Rooms protected and left tidy
Read our prices page and guide to resurfacing and replacement costs.
DIY repairs versus a professional job
What a professional repair adds is preparation, colour matching and finishing. We clean and key the area properly, mix the colour to your surface and finish it to the same sheen, and the work is guaranteed.
If you’ve already tried a DIY fix, that’s fine. We take the old repair out and do it properly, so it doesn’t stop a professional repair. It does add a little time, so tell us about it when you send photos.
Errol questions
Can you do more than one item on the same visit?
Yes. Combining jobs on one visit brings the cost down. Include photos of each item.
Will there be a smell?
There can be some smell while we work. It fades as everything cures.
Can you do the outside of a roll-top?
Yes. We can do the inside and outside.
Which areas do you work in?
We work UK-wide, so Errol is covered. Prices don’t change with location.
Can you quote from pictures?
Normally, yes. A close-up and a wider photo are enough to give a fixed price.
Can you change the colour of my bath?
Yes. We can resurface a coloured bath in white, and the basin and toilet can be done too.
Do you work in Errol?
Yes. We cover the whole UK and travel to Errol and the rest of Perth and Kinross. Send photos and we’ll quote, or call 0345 017 0787.
I rent my home. Can I book you?
We can work for tenants, landlords or agents. Get your landlord’s agreement first.
Errol and the surrounding area
Errol is about 9 miles east of Perth, in Perth and Kinross. Whether you are in the middle of Errol or on the outskirts, the service is the same: fixed prices, tidy work and a one-year guarantee. Errol is one of 107 towns and villages in Perth and Kinross where we work. Our jobs stretch from Errol to Edinburgh (31 miles away).
Postcode districts we cover here: PH2. Whether you live on Station Road, High Street and North Bank Dykes or a nearby road, we can come to you. Other places close to Errol include Grange (2 miles north-east), Newburgh (3 miles south), Glencarse (4 miles west), St Madoes (4 miles west) and Lindores (4 miles south). We also work in nearby towns such as Perth (9 miles west), Blairgowrie and Rattray (14 miles north), Kinross (15 miles south-west), Letham (10 miles west), Scone (8 miles west) and Tulloch (10 miles west).
Around Errol
Our clients here include homes close to Errol Parish Church, among other places. A little further out are Laing Museum (3.2 miles south) and Ballinbreich Castle (1.9 miles south-east). Open spaces near Errol include Lindores Loch and Norman's Law.
Prices and what affects them
Resurfacing from £350. Prices are worked out job by job, from your photos. What matters most is:
- How much damage there is
- The type of damage
- Any earlier repairs that need removing first
- Doing more than one item at once
The price depends on how much damage there is and what kind, the material and how many items we do on one visit. We give a fixed price from your pictures, so there are no surprises on the day.
Quotes from your pictures
The better the pictures, the more accurate the price. Here’s what helps:
- A close-up of the damage, in focus
- Something in shot to show the size
- Your postcode, so we can check dates
- Good light, ideally daylight, without flash glare
No survey visit is needed: we price from photos. Send them through the quote form, or call 0345 017 0787 if you’d rather talk it through, and you will get a fixed figure back.
When we’d advise against a repair
A few problems are outside what a surface repair can do:
- A metal bath with a through crack
- Plumbing leaks, which need a plumber
- Steel that has corroded right through
If in doubt, send photos and we will say what we think before you book.
What we work on
- Cast iron baths
- Acrylic baths
- Victorian roll-tops
- Pressed steel baths
- Basins & shower trays
Different materials, different repairs
Roll-top and period baths
We can resurface a roll-top inside and out, with the outside refinished as well.
Cast iron
Re-enamelling suits cast iron baths perfectly. They’re built to last, and only the surface wears, so a new finish makes them look new again.
What else we do in Errol
Looking after it afterwards
Aftercare is simple, and it makes a real difference:
- Don’t use the bath until it has fully cured
- A dripping tap should be fixed promptly
- Rinse off hair dye, oils and bath bombs right away
- Never use suction bath mats
Use mild, non-abrasive cleaners, do not use suction bath mats, and keep bottles and razors off the surface.
Don’t try to scrub a worn bath back to shine. It removes more of the surface.
When to call us in Errol
A dull surface stains and holds dirt, and cleaning harder only makes it worse. At that stage, resurfacing is the fix.
If you can see any of these, send us a photo:
- A coating lifting around the plughole
- A dull, rough surface that won’t come clean
- Thin, worn enamel in places
- Stains that won’t shift
What your quote should include
- Whether the price is fixed and includes VAT
- How long it needs to cure
- How the colour is matched
- What preparation is included
How the visit works
There’s not much you need to do on the day. Show us the job, point us to the room, and we’ll take it from there. Most visits take a full day, tidy-up included.
- First we look the bath over and confirm the finish.
- Everything around the bath is masked and covered.
- The bath is degreased, repaired and keyed.
- We apply the primer and then the finish coats.
- The masking comes off, we tidy up and tell you when it can be used.
Getting ready for the visit
- Let the surface dry out before the visit
- Open a window if you can
- Point us to the nearest place to park
Ask for a price
If you are in Errol and want a price, pictures are the quickest way: one close up, one from further back, plus your postcode. We reply with a fixed quote and our next available dates.
Advice
About our accreditations · Every repair comes with a one-year guarantee.
