Scotland

Bath Re-enamelling in Moray

We travel to 58 towns and villages in Moray for bath re-enamelling, with everything done in place and a one-year guarantee.

Book bath re-enamelling in Moray

Call 0345 017 0787

Get a free quote

Bath re-enamelling across Moray

Full bath re-enamelling and resurfacing. Pick your town below to see the details for your area, and send us photos for a free, fixed quote.

Largest places

Bath re-enamelling at your home in Moray

Re-enamelling is a one-day job for most baths, with the bath ready to use the following day. Nothing is disconnected or removed. Typical jobs include a coating lifting around the plughole and thin, worn enamel in places, in basins & shower trays, pressed steel baths and acrylic baths.

The work is clean and fairly quiet. Protection goes down first, then the job itself takes most of the day. Before we leave, we explain how soon it can be used and how to care for it.

First we look the bath over and confirm the finish.
Everything around the bath is masked and covered.
We degrease the bath, fix any damage and key the surface.
We apply the primer and then the finish coats.
The masking comes off, we tidy up and tell you when it can be used.

Prices in Moray

Prices start from £350. A repair usually costs much less than people expect, especially compared with replacing and refitting. Send photos and we will give you the exact figure.

Why choose Surface Doctor

We come to you, anywhere in the UK
Every repair guaranteed for a year
Accredited with CHAS, Constructionline and SafeContractor
Rooms protected and left tidy

Get a quote

Getting a price is easy: take a close-up of the damage and a picture from further back, send them to us with your postcode, and you will get a fixed price back. There’s no charge for the quote and no obligation.

Around Elgin

In Elgin, that means homes near The Muckle Cross pub, Cooper Park and St Columba's Church of Scotland, among other places. There’s a railway station in Elgin itself: Elgin station. Other landmarks nearby include Dr Gray's Hospital (0.6 miles west) and St Giles Centre (within half a mile north-west). For a walk, there’s Loch Spynie.

Landlord and trade work in Moray

Hotels, guest houses and holiday lets cannot afford rooms out of action for long, so most of our work is done in a single visit. We can work around your bookings.

We regularly work with letting and managing agents. Send the address, pictures and access details.

What a repair cannot fix

We won’t take on work that will not last, so these are the limits:

A cast iron or steel bath that is cracked right through
Plumbing leaks, which need a plumber
Anything hidden under an old coating, until we remove it

DIY repairs versus a professional job

It’s tempting to reach for a kit, but the repairs we redo most frequently are DIY ones that have discoloured or lifted. Getting it right first time is normally cheaper.

If you’ve already tried a DIY fix, that is fine. We take the old repair out and do it properly, so it does not stop a professional repair. It does add a little time, so tell us about it when you send photos.

How to care for the repair

After the repair has cured, a few habits help it last:

Wipe the bath dry after use in hard water areas
Clean with a soft cloth and mild detergent
Don’t leave bottles, razors or sponges standing on the surface
Wash away dyes and oils after use

Rinse away dyes, oils and bath bombs straight after use, as they can stain. Repair dripping taps promptly.

Leave a peeling coating alone. Moisture gets underneath and makes it worse, so have it stripped and resurfaced.

Different materials, different repairs

Acrylic

Acrylic feels warm and is light, but it relies on good support. Repairs to cracks are reinforced from the back.

Cast iron

Cast iron baths are so heavy that repairing in place makes obvious sense. Only the enamel surface wears or chips, and that’s the part we put right.

Your questions about bath re-enamelling in Moray

Is there a call-out fee?

No. Our quotes include travel, and we charge the same wherever you are.

Can you change the colour of my bath?

Yes, most people go for white. Tell us what you’d like when you ask for a quote.

Do you resurface freestanding baths?

Yes, frequently. The inside is resurfaced, and we can refinish the outside as well.

Is there a smell?

Some odour is normal while we spray, so we ventilate the room. It fades as the coating cures.

How long does re-enamelling take?

One day for most baths and can be used the day after. We give you timings with the quote.

I rent my home. Can I book you?

Yes, but check with your landlord or agent first. Landlords are often glad to have it sorted.

Do I need to be at home?

Yes. The technician needs access to the room for the visit, at a time we agree with you.

CHAS accredited contractor and Constructionline logos

About our accreditations · Every repair comes with a one-year guarantee.